100 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 5 Use the Keypad Interface
Device Information Screen
Version Information Screen
This screen displays hardware and firmware versions of the drive. The display
string is .
h represents the hardware version, and F represents
the firmware version.
Setting Screen
When the drive is disabled/servo off, the Setting screen lets you edit the network
address or drive parameters, or reset the drive.
For more information, see Edit Settings From the Display
on page 101.
Drive Status Name Display String Description
Standby Stdby If the drive has passed boot steps and self-testing, but the drive has not
been configured.
Stopped StoP If the drive has been configured, but it is still not enabled/servo on.
Running RUN The drive is enabled/servo on.
Fault A fault or warning occurred during operation.
• DHCP o: Stdby 192.168.1.180
•
DHCP on (before IP address is assigned): Stdby DHCP 0.0.0.0
• DHCP on (after IP address is assigned): Stdby DHCP 192.168.1.180
To Next Page
Loading...
