Allen-Bradley Kinetix 5100 2198-E1020-ERS - Page 110

110 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 6 Set Up EtherNet/IP Communication
2. In the Device Information screen or Drive Status screen, the current IP
address is shown.
3. Press key.
SETTING appears on the display.
4. Press key.
NET SETTING scrolls across the display.
5. Press key.
STATIC IP scrolls across the display.
To enter the IP ADDR, press key, and use the keys to enter the IP
Address octets.
To enter the SUBNET, press key, and use the keys to enter the
subnet address octets.
To enter the GATE, press key, and use the keys to enter the
Gateway octets.
Press to return to the Static IP display.
6. Press key.
DHCP appears on the display.
To show the current DHCP setting (OFF or ON), press key.
To change the DHCP setting, and press or key.
The display toggles between OFF and ON.
To apply the setting, press key or to exit the setting press keypad.
See Chapter 5
, Use the Keypad Interface for help with setting the network
parameters
Drive
Status
Device
Information
Version
Information
Setting
Information Display/Setup Mode