Summary of Changes
The information below summarizes changes made for the July 2017
PowerFlex 4 User Manual, Publication 22A-UM001K-EN-E.
The information below summarizes changes made for the June 2013
PowerFlex 4 User Manual, Publication 22A-UM001J-EN-E.
The information below summarizes changes made for the September
2010 PowerFlex 4 User Manual, Publication 22A-UM001I-EN-E.
The information below summarizes changes made for the July 2010
PowerFlex 4 User Manual, Publication 22A-UM001H-EN-E.
The information below summarizes changes made for the March 2007
PowerFlex 4 User Manual, Publication 22A-UM001G-EN-E.
Description of New or Updated Information See Page(s)
Line fuse footnote added to Fuse Rating column. 1-7
Low Voltage Directive updated. 1-20
Attention statement on Option 3 “2-W Lvl Sens” and Important statement
about Option 4 “2-W Hi Speed” added to parameter P036 [Start Source].
3-9
Specifications table Approvals column updated. A-2
Sound Pressure Level specification added. A-3
Product Environmental Information added. A-4
Dynamic Brake Fuse Rating column and new footnote added. B-2
Network Wiring topic updated. C-1
Description of New or Updated Information See Page(s)
Minimum Enclosure Volume column and new footnotes added. 1-7
, A-2
Drive, Fuse & Circuit Breaker Ratings topic updated. A-1
Electronic Motor Overload Protection description updated. A-3
Description of New or Updated Information See Page(s)
Parameters A117 [Bus Reg Mode] and A118 [Comm Write Mode] added. 3-13
Description of New or Updated Information See Page(s)
Start and Speed Reference Control
1-18
Description of New or Updated Information See Page(s)
Minimum Mounting Clearances clarified. 1-2
Footnote (2) on Bulletin 140M catalog edited. 1-7
Graphic for Analog Input, PTC wiring example corrected. 1-14
To Next Page
Loading...
