126 Rockwell Automation Publication 520-UM001A-EN-E - February 2013
Chapter 3 Programming and Parameters
AppView Parameter Groups
PowerFlex 525 drives include various AppView parameter groups that groups
certain parameters together for quick and easy access based on different types of
applications. These applications include:
• Conveyor
• Mixer
• Compressor
• Centrifugal Pump
• Blower/Fan
• Extruder
• Positioning
• Textile/Fiber
You cannot add or remove parameters to or from the AppView parameter groups.
If you require quick access to additional parameters to what is already included in
the different AppView parameter groups, use the CustomView parameter group
instead.
The parameters in the AppView parameter groups can be quickly added to the
CustomView parameter group by doing the following:
Step Key(s) Example Displays
1. Press the Up Arrow or Down Arrow to scroll to
an AppView group (G1...G8).
2. Press Enter or Sel to enter a group. The right
most digit of the last viewed parameter in that
group will flash.
3. Press the Up Arrow or Down Arrow to scroll to
the command G1->GC.
4. Press Enter or Sel to add all the parameters in
this AppView group to the CustomView group.
The LCD display will show a confirmation.
F
W
D
F
W
D
F
W
D
To Next Page
Loading...
Need help?
General
