Allen-Bradley PowerFlex 6000 Installation Instructions

54 Rockwell Automation Publication 6000-IN006F-EN-P - March 2018
Appendix D Power Cabling and Control Signal Wiring Details
Figure 31 - Terminal Strip Wiring Diagram for Drive System without a Bypass Cabinet

     
$

$

$
/ 1
                     
'7%
  
'7%
         

%
'&'
5;' 7;' 

*1' 576 &76
$
   

  
$

$

$

$

$

$

$

$
      
a
L 120V AC
From Customer To Remote DCS (Reserved)
NOTE: 1. 4...20 mA shielded cable from customer input shall be grounded at the inverter side. 2. Remote DI input to drive shall be of pulse type with a duration of three seconds, shielded cable. 3. Connection marked with dotted line shall be in the customer’s scope of supply.
From CB (or vacuum contactor) To Remote DCS To CB To Customer Vacuum Contactor (Reserved) E-Stop Status (Reserved)
N0V AC MV Closed MV Pre-Closed CB MV Closed Warning Fault Drive Running Drive Stop Ready Remote DCS Control MV Pre-Closed CB MV Closed Warning Fault Drive Running Drive Stop Ready Remote DCS Control Pre-Closed CB (NO) CB Open (NO) Pre-Closed CB (NC) (Reserved) CB Open (NC) (Reserved) MV Close (NO) (Reserved) Emergency Stop
From Remote
Reserved Reserved Reserved Reserved Reserved Reserved Reserved Reserved +24V DC Remote DCS Fault Reset Reserved
Reserved
Reserved Remote Start Remote Stop
To Remote
From Remote
MODBUS / RS485
Current Output 4...20 mA Frequency Output 4...20 mA Speed Input 4...20 mA Analog Input 4...20 mA (Reserved) Analog Input 4...20 mA (Reserved)
From Remote DCS
E-Stop Status (Reserved)

Allen-Bradley PowerFlex 6000 Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 6000
Category	DC Drives
Language	English