Need help?Do you have a question about the Allen-Bradley PowerFlex 6000T and is the answer not in the manual?
General| Brand | Allen-Bradley |
|---|---|
| Model | PowerFlex 6000T |
| Category | DC Drives |
| Language | English |
Information about practices causing explosions in hazardous environments.
Information about practices causing personal injury or death, property damage, or economic loss.
Alerts about dangerous voltage present on equipment.
Alerts about hot surfaces on equipment.
Alerts about potential Arc Flash, severe injury or death risk.
Includes generic drive cabinet layout and electrical connection info. Review project-specific drawings.
Important safety and handling precautions for ESD, incorrect application, and servicing.
Specifies required environmental conditions for elevation, temperature, humidity, vibration, and air quality.
Instructions for connecting shipping splits, including an attention note about leveling.
Instructions for securing cabinets to the floor using anchor bolts.
Instructions for installing the drive for seismic conditions, covering two conditions.
Information on installing power modules, including use of lift cart.
Requirements for externally ducting exhaust air and drawing cleansed outside air.
Electrical safety guidelines and compliance with national/local codes for installation.
Guidelines for low impedance and sufficient capacity grounding paths.
Instructions for connecting line and motor power cables, including table of power terminals.
Details the electrical safety interlock circuit's function and importance.
Provides an overview of power cable interconnections between cabinets.
Explains orientation and connection of isolation transformer secondary power cables.
How to connect motor and voltage sensing board cables to power module arrays.
Final checks and steps to complete the drive installation.
Tasks customer must complete before Rockwell Automation schedules commissioning.
Process for completing and submitting the pre-commissioning checklist.
Table of proper tightening torque values for various thread sizes.
Identifies general wire categories, recommended cables, and conductor groups.
Provides schematic diagrams for drive systems with and without bypass cabinets.
Lists standard I/O connection points for the drive and option -24TAOP.
Informative data on line and load cable sizes for A-Frame drives (IEC and UL).
To Next Page
