Rockwell Automation Publication 6000-IN100A-EN-P - August 2020 9
Chapter 1
Drive Mechanical Installation
The installation process is divided into three principal activities. The
mechanical installation process described in this chapter, the electrical
installation process described in Drive Electrical Installation
on page 33, and
the electrical interconnection process described in Drive Electrical
Interconnection on page 47.
Mechanical Installation
Summary
The cabinets must be arranged as shown in the Dimensional Drawing (DD).
Follow all applicable guidelines for siting the components before continuing
with these installation instructions.
There may be some variation in the process depending on the type and number
of drive components in your particular installation.
Connect Shipping Splits
Connect DV/DT Filter Cabinet for A-Frame Drives
The standard A-Frame for PowerFlex 6000T drives comes fully assembled and
does not require any shipping splits. However, if a DV/DT filter is included
with the drive then there is one shipping split, and the drive and filter needs to
be connected as follows:
1. Remove the M16x16 countersunk screw that secures the LV covers and
grounding cover at the right side of the main drive, and the left side of
the filer cabinet. Then remove the covers.
2. Arrange the sections as described in the Dimensional Drawings and
move the sections together.
3. Align the cabinet side sheets together at the holes f
or the hardware.
Connect Shipping Splits 9
Affix Cabinets to Floor 13
Install Seismic Rated Enclosures 16
Install Main Cooling Fans 23
Install Power Modules (if applicable) 26
External Ducting 30
ATTENTION: Install the drive on a level surface (+/- 1 mm per meter
[+/- 0.036 in. per 36 in.] of drive length in all directions). If necessary, use
metal shims to level the cabinets before joining them; attempting to level
after joining may twist or misalign the cabinets.
To Next Page
Loading...
