Publication 2711-UM014B-EN-P
12-22 Terminal Connections
Connecting to a MicroLogix Controller through an AIC+
This section shows how to connect the RS-232 (DH-485) version of
the PanelView terminal to a MicroLogix controller through an AIC+
Link Coupler.
Connecting a Computer
This section shows how to connect a computer to the RS-232
(DH-485) PanelView terminal for transferring applications.
AIC+
Cat. No. 1761-NET-AIC
MicroLogix 1000, 1200, 1500LSP
PanelView 1000
Belden Cable 9842
RS-232 Communication Cables
Cable, Cat. No. 2711-NC13
Cable, Cat. No. 2711-NC14
Cable, Cat. No. 2706-NC13
Note: On PanelView 550 terminals, pin
8 on the RS-232 connector is pulled
high. Do not use the 2711-NC13 cable.
Catalog No.
1761-CBL-HM02
1761-CBL-AM00
Catalog No. 1747-CP3
Computer
PanelView 1000
Computer
RS-232 Communication Cables
Cat. No. 2711-NC13, 5 m (16.4 ft)
Cat. No. 2711-NC14, 10 m (32.7 ft)
Cat. No. 2706-NC13, 3 m (10 ft)
To Comm1 or Comm2 Port
To RS-232
Communications Port
25-pin to 9-pin
Adapter
(if required)
To Next Page
Loading...
