Allen-Bradley Stratix 6000 - Reset IP Address; Change Settings to Default

54 Rockwell Automation Publication 1783-UM001B-EN-P - May 2010
Appendix C Factory Reset
Reset IP Address
To reset only the IP address, use this procedure.
1. With power applied, push the reset button with a small screwdriver.
2. Hold the button in for 30 seconds.
3. Cycle power to complete the IP reset.
Your IP address defaults to 192.168.1.1.
Change Settings to Default
To change all settings back to default, use this procedure.
1. Remove power.
2. Push the reset button with a small screwdriver.
3. Apply power while continuing to hold the reset button.
4. Hold the button in for 30 seconds.
5. Cycle power to complete the reset.