70 Rockwell Automation Publication 1783-UM001B-EN-P - May 2010
Appendix F Work with RSLogix 5000 Software, Version 15 or Later
• Program Mode Behavior
– Default value is Enable All Ports.
– Enable all ports when the Logix controller is put in Program mode. If
the Logix controller is disabling a port, it is enabled if the Logix
controller is put in Program mode.
– Hold last state when the Logix controller is put in Program mode. If a
port is disabled by the controller, it continues to be disabled when the
controller is put in Program mode. To re-enable all of the ports, the
1783-EMS switch requires a power cycle.
– Apply safe state values to ports when the Logix controller is put in
Program mode. Port status can be changed when the Logix controller is
put in Program mode.
To Next Page
Loading...