Alliance Laundry Systems DTB50CG - Heating Element Does Not Heat or Burner Does Not Ignite - Gas and Electric Models

16 70410501
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Troubleshooting
5. Heating Element Does Not Heat Or Burner Does Not Ignite – Gas and
Electric Models
Heating element does
not heat or burner
does not ignite
Is there
an improper or
inadequate exhaust
system?
No
Are there
blown fuses or
tripped circuit breakers
in external electric
supply line?
Is
drying timer
not selected or
inoperative?
No
Refer to
Installation
Manual for
exhaust system
requirements.
Ye s
Check fuses or
circuit breaker.
Ye s
Set drying timer
or replace if
inoperative.
Ye s
Is
thermostat
inoperative?
Ye s
Test thermostat
and replace if
inoperative.
Is there
inadequate
ductwork and
make-up air?
Clean lint compartment.
Check damper for lint
accumulation. Check
ductwork for lint buildup.
Ye s
Refer to Installation
Manual to ensure that
ductwork and make-up
air openings are sized
accurately.
Ye s
Is there
lint
buildup?
TMB2134S-a
No
Continued on
next page
Is the
airflow switch
inoperative?
Ye s
Test switch and replace if
inoperative.
Check back draft damper
for foreign objects, lint
accumulation or other
causes that may prevent
damper from opening.
Check exhaust outlet. If a
screen has been
improperly installed on
the outlet, it may be
clogged with lint or frozen
over in winter. NEVER
install a screen over the
exhaust outlet.
Is airflow
switch out of
adjustment?
No
Ye s
Refer to Installation
Manual for airflow
switch adjustment.
No
No
No
Is
there broken,
loose or
incorrect
wiring?
Ye s
Refer to
wiring diagram.
Is the lint
door panel
not closed
properly?
Ye s
No
Open lint door
panel, place lint
door and panel
back on tumbler
(ensuring a tight fit).
No
No