Alliance Laundry Systems SA025L - Page 73

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Testing Machine and Electronic Control Functions
71
70417701
Machine Configuration Display #1 Test
This option shows the machine configuration values.
To start test, control must be in the Testing Mode.
Refer to “How to Enter Testing Feature” at the
beginning of this section.
To enter, press the START (enter) keypad. The display
will show “bxxx”, with “xxx” a number corresponding
to whether or not coin drops are connected, or serial
card reader or network board are connected.
Refer to Table 17 for test information.
To exit Machine Configuration Display #1 Test, press
the MED TEMP (<) keypad. The control will return to
the testing mode.
Machine Configuration Table
CONFIG
VALUE
NETWORK
BOARD
PRESENT
CARD
READER
PRESENT
COIN DROP
#2
PRESENT
COIN DROP
#1
PRESENT
17 OFF OFF OFF ON
18 OFF OFF ON OFF
19 OFF OFF ON ON
20 OFF ON OFF OFF
25 ON OFF OFF ON
26 ON OFF ON OFF
27 ON OFF ON ON
28 ON ON OFF OFF
Table 17