Alliance Laundry Systems UD13F063 - First Start-Up

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
23
1300003 (EN)
First Start-Up
1. Verify that the finisher is stable and level. Use the
heated roll to check level, not the cabinet.
2. Check that all connections and exhausts are
correctly established.
3. Check that the finisher is properly grounded.
4. Remove wax paper from cylinder, if applicable.
a. Remove protective paper from below feeding
table. Refer to Figure 12.
Figure 12
b. Remove protective paper manually. Be
especially careful around separation blade and
temperature sensor. Refer to Figure 13,
Figure 14 and Figure 15.
c. Turn roll with crank handle. Refer to
Figure 16.
FWF109N
FWF110N
Figure 13
FWF109N
FWF110N
FWF111N
Figure 14
FWF112N
Figure 15
FWF113N
Figure 16
FWF111
N
FWF112N
FWF113N