© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
1300003 (EN)
36
Thermostat Inspection
To clean the thermostat and its surrounding area,
follow these steps and refer to Figure 25.
1. Gently press on the thermostat holder so the
thermostat lifts up.
2. Rotate the thermostat holder 90 degrees.
3. Clean the thermostat holder if debris is present.
4. Clean the inside surface of the thermostat and its
surrounding area if debris is present.
5. Place the thermostat holder back in its original
position so the thermostat is touching the
cylinder.
Cleaning the Scrapers
To clean the scrapers that guide the linen from the
ironing cylinder into the output tray, use clean hands to
gently wipe off any debris. Refer to Figure 25.
Waxing the Ironing Cylinder
IMPORTANT: If the finisher will not be used for
more than a week, the ironing cylinder must be
coated with paraffin wax to prevent it from rusting.
To coat the ironing cylinder with paraffin wax, follow
these steps and refer to Figure 26.
1. Turn off the heat and proceed while the ironing
cylinder is still warm.
2. Use a 5 mm Allen wrench to remove the top
panel from the finisher.
3. Rotate the ironing cylinder at low speed.
4. Carefully hold a block of paraffin wax against
one end of the cylinder and slowly move it along
the length of the cylinder toward the other end.
5. Continue to apply the wax from one end of the
cylinder to the other until the entire cylinder has
an even coat of paraffin wax.
6. Stop the finisher.
7. Replace the top panel on the finisher.
FWF8N
1 Thermostat Holder
2 Scrapers
3 Thermostat
Figure 25
FWF9N
1 Ironing Cylinder
2 Press-Roller
3 Guide Ribbons
4 Paraffin Wax
5 Return Ribbons
Figure 26
To Next Page
Loading...
