Alliance Laundry Systems UD13F063 - Default Chapter; Table of Contents

© Copyright 2012, Alliance Laundry Systems LLC
All rights reserved. No part of the contents of this book may be reproduced or transmitted in any form or by any
means without the expressed written consent of the publisher.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
2
1300003 (EN)
Table of
Contents
Introduction......................................................................................... 4
Serial Plate Location............................................................................. 4
Replacement Parts ................................................................................ 4
Customer Service.................................................................................. 4
Model Identification ............................................................................. 4
Safety Information.............................................................................. 5
Explanation of Safety Messages........................................................... 5
Safety Notice ........................................................................................ 8
Important Safety Instructions ............................................................... 8
Installation........................................................................................... 10
Pre-Installation Inspection .................................................................... 10
Overall Dimensions and Connecting Data ........................................... 11
Required Materials................................................................................ 12
Location Requirements......................................................................... 12
Lifting the Finisher ............................................................................... 12
Moving the Finisher with Rollers ......................................................... 13
Electrical Requirements........................................................................ 15
Grounding Instructions .................................................................... 15
Electrical Connection....................................................................... 16
Gas Connection..................................................................................... 17
Gas Technical Specifications for CE Models .................................. 18
Inlet Pressure.................................................................................... 18
Manifold Pressure ............................................................................ 18
Gas Conversion..................................................................................... 19
Adjustments and Flow Rates for Non-CE Models .......................... 20
Adjustments and Flow Rates for CE Models................................... 20
Exhaust Requirements .......................................................................... 21
Individual Venting ........................................................................... 22
First Start-Up ........................................................................................ 23
Operation............................................................................................. 25
Operating Instructions for
Microprocessor Models Starting October 2003 ................................. 25
Operating Controls........................................................................... 25
Pre-Operating Procedures ................................................................ 26
Operating Instructions ..................................................................... 26
Operating Instructions for
Electromechanical Models Through September 2003 ....................... 28
Operating Controls........................................................................... 28
Pre-Operating Procedures ................................................................ 29
Operating Instructions...................................................................... 29
Regulating the Cylinder Heat........................................................... 30
Breakdown Procedures ......................................................................... 31
Alarms .................................................................................................. 31
Insufficient Air Flow (Gas Models Only)........................................ 31
Emergency Safety Bar ..................................................................... 31
Thermal Warning Fan ...................................................................... 32
Speed Regulator Alarm.................................................................... 32