© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT1300003 (EN)
3
No Flame (CE Gas Models Only).................................................... 32
Overheating or Sensor Not Connected ............................................ 32
Extended Periods of Non-Use .............................................................. 32
Maintenance ........................................................................................ 33
Check Operation of Air Vacuum Switches .......................................... 33
Feeding Ribbon Tension Adjustment ................................................... 33
Return Ribbon Tension Adjustment ..................................................... 34
Press-Roller Pressure Adjustment ........................................................ 35
Press-Roller Drive Chain Tension Adjustment .................................... 35
Thermostat Inspection .......................................................................... 36
Cleaning the Scrapers ........................................................................... 36
Waxing the Ironing Cylinder................................................................ 36
Removing Rust From Ironing Cylinder................................................ 37
Periodic Maintenance ........................................................................... 37
Daily................................................................................................. 37
Weekly ............................................................................................. 37
Every 200 Hours .............................................................................. 37
Every 2000 Hours ............................................................................ 37
Replacement of Feeding Ribbons......................................................... 38
Replacement of Return Ribbons........................................................... 40
Replacement of Supporting Rollers...................................................... 41
Replacement of Side Rollers ................................................................ 41
Troubleshooting Undesirable Finishes ................................................. 42
Troubleshooting Hot Surface Ignition Module
(120 Volt Gas Models Only).............................................................. 43
Status LED Used to Troubleshoot ................................................... 43
Ignition System Checks ................................................................... 44
To Next Page
