Alliance Laundry Systems UD13F063 - Replacement of Feeding Ribbons

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
1300003 (EN)
38
Replacement of Feeding Ribbons
To replace the feeding ribbons, perform the following
steps.
1. With a standard screwdriver, pop clamp open at
left end of feeding roller. Refer to Figure 27.
2. Remove clamp from roll.
3. Peel back adhesive strip from left side of feeding
roller to expose roller pin. Refer to Figure 28.
4. Using a center punch, completely knock out
feeding roller pin. Refer to Figure 29.
5. Remove screw from left side of top panel (behind
feeding roller). Refer to Figure 30.
FWF22N
1 Left Side of Finisher
2 Top Panel
3 Screwdriver
4 Clamp
5 Feeding Roller
Figure 27
FWF23N
1 Top Panel
2 Roller Pin
3 Feeding Roller
4 Adhesive Strip
Figure 28
2
3
4
5
1
1
2
3
4
FWF24N
1 Roller Pin
2 Feeding Roller
3 Top Panel
4 Feeding Ribbon
Figure 29
FWF25N
1 Screw
2 Top Panel
3 Feeding Ribbon
Figure 30
1
2
3
4
1
2
3