Alliance Laundry Systems UT025 - Programming the Electronic OPL Control; Introduction to Programming

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
9
70381401
Programming the Electronic OPL Control
Figure 1
Introduction to Programming
Drying can be done automatically or by time dry.
When drying automatically, the tumbler stops drying
when laundry reaches the factory-set or programmed
dryness level and starts Cool Down. When time
drying, the tumbler stops drying when programmed
time ends and starts Cool Down.
Both Automatic Dry and Time Dry have factory-set
cycles, but other cycles can also be created. Frequently
used cycles can be saved in the control's memory as
Custom cycles.
In all cycles except No Heat, Wrinkle-Free begins
when Cool Down ends. During Wrinkle-Free, the
tumbler alternately stops for 2.5 minutes and then runs
without heat for 2.5 minutes until door is opened or 60
minutes has elapsed.
A Custom heat cycle may be saved in one of four ways
using the ON/SELECT pads of HIGH, MEDIUM,
MED LOW and LOW. Refer to Table 1.
Table 1
T359I
NOTE: Not all tumblers will have reversing option.
STATUS
DRYING
COOL DOWN
DOOR OPEN
CUSTOM
HIGH
MEDIUM
MED LOW
LOW
NO HEAT
TEMP
DISPLAY
SIGNAL
F/ C
TEMP
PROGRAM
AUTO
SPECIAL
CYCLE
MORE
CONDITION
SPECIAL
TIME
COOL
DOWN
LESS
SAVE
CUSTOM
TIME
*
+--
*
PROG
AUTO
AUTO
ON / SELECT
START
STOP/RESET
REVERSING
One preprogrammed
No Heat cycle
Four preprogrammed
Automatic Dry heat
cycles
All of these cycles
may be used as
preprogrammed
from the factory . . .
They may be
modified for one
cycle without
being saved in
the memory . . .
They may be
modified and
saved in the
memory as Custom
cycles.
OR OR
Custom Cycles
Automatic Dry Dries the load to one of eleven user-
selectable dryness levels for a given
fabric type, and then enters automatic or
user-variable Cool Down.
Time Dry Duplicates the functions of
electromechanical dual timer controls,
allowing the user to vary temperature,
drying time and Cool Down time.
Special Cycle Allows the user to specify the number
of heating cycles and to select from the
full range of temperatures for all heat
cycles.
Special Time Similar to Time Dry, except that the
user may specify from 80°F (27°C) to
180°F (82°C) for any heat cycle.