Alliance Laundry Systems UT025 - Signal; Reversing; Status Lights

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT
Programming the Electronic OPL Control
70381401
10
Signal
Refer to Figure 3.
The signal has three loudness levels that can be set
anytime the control is activated. Pressing the SIGNAL
pad once produces the softest tone. Press the pad again
to increase signal volume. The fourth press turns the
tone and light off. The loudness level selected is for all
cycles until changed.
When the signal is on and any key pad is pressed, it
sounds at the selected level to confirm the pad was
properly pressed.
Reversing
Refer to Figure 3.
NOTE: Not all tumblers will have the reversing
option.
When this is selected, the cylinder will rotate in one
direction for 25 seconds, pause for six seconds, then
rotate in the opposite direction for 25 seconds.
This sequence will repeat until the selected cycle ends.
To turn reversing option off, press the REVERSING
pad. (Anytime REVERSING pad is pressed, the
cylinder will pause for six seconds.)
Status Lights
Refer to Figure 3.
NOTE: Do not press directly on lights or the center
of pad. For proper selection, press on pad slightly
to the right of center. Refer to Figure 2.
Figure 2
DOOR OPEN
Lights when door is open.
NOTE: Display window also
flashes.
DRYING
Lights when laundry is drying.
COOL DOWN
Lights when laundry is cooling.
CUSTOM
Lights when a Custom cycle is
programmed, recalled or running.
SIGNAL
When lit, the signal will sound when
the laundry is ready for removal.
REVERSING
When lit, the cylinder will rotate in
one direction for 25 seconds, pause
for 6 seconds, then rotate in the
opposite direction for 25 seconds.
T398I
Figure 3
STATUS
DRYING
COOL DOWN
DOOR OPEN
CUSTOM
SIGNAL
REVERSING
T398I
STATUS LIGHTS