What to do if there is a problem with Allied Telesis Gateway telephone service?
If you're experiencing issues with your telephone service, try these steps: First, replace the existing cable with a cable that you know is working correctly. For POTS phones and fax machines, ensure the dial mode is set correctly as described in their respective manuals. Also, inspect the telephone or fax machine itself for any potential issues.
What to do if the VOIP LED is off on Allied Telesis Gateway?
If the VOIP LED doesn't light up when you lift the phone receiver, ensure the telephone cable is correctly connected, undamaged, and is the right type of cable. Try plugging a known good POTS telephone into the RJ-11 jack. If the VOIP LED lights up, the issue is likely with the original telephone cable. If it doesn't light up, there might be a problem with the iMG. In that case, verify the configuration, or reset the iMG to its factory defaults using the command sequence >system, >configure terminal, and then >boot config-file default.cfg. If problems persist after these steps, it is recommended to contact Allied Telesis.
How to fix Allied Telesis Gateway that is not operating correctly?
If the Gateway isn't working as expected, try resetting it. Disconnect the power cable, and then reconnect it.
What to do if the SYST LED is red on Allied Telesis Gateway?
If the SYST LED is red, unplug the power cable, wait 20 seconds, and then plug it back in. If the LED remains red, unplug the power cable and contact Allied Telesis.
Why is the WAN LED off on my Allied Telesis Gateway?
If the WAN LED is off, check the fiber optic port and connector on the pigtail to ensure they are clean. Also, verify that the connector is properly seated in the fiber optic port and that the fiber optic cable has an active light source.
How to troubleshoot Allied Telesis Gateway PWR LED being off?
If the PWR LED is off, check the power cable to make sure it's undamaged and properly connected.
Details FCC compliance requirements and conditions for device operation.
Provides essential safety precautions to review before installing the gateway.
Guides on the process of installing the gateway in an outdoor enclosure.
Provides instructions for installing the gateway in an indoor environment.
Details the step-by-step procedure for powering up and initializing the gateway.
Offers solutions to common problems encountered during gateway operation.
General| Switching Capacity | 88 Gbps |
|---|---|
| Power Supply | Internal |
| Device Type | Managed |
| SFP+ Ports | 2 |
| MAC Address Table Size | 16K entries |
| VLANs | 4094 |
| Power Input | 100~240V AC, 50/60Hz |
| Operating Temperature | 0°C to 40°C (32°F to 104°F) |
| Mounting | Rack-mountable |
| Standards Compliance | IEEE 802.3 IEEE 802.3u IEEE 802.3ab IEEE 802.3z IEEE 802.3x IEEE 802.1D IEEE 802.1w IEEE 802.1s IEEE 802.1Q IEEE 802.1p |
| Management | Web-based GUI, CLI, SNMP |
To Next Page
