12 Rapier Switch User Guide
Software Release 2.6.1
C613-02025-00 REV C
■ Demand IPX
■ IPX/SPX Spoofing
■ IPX Filtering (not between switch ports)
■ AppleTalk
■ Resource Reservation Protocol (RSVP)
■ BGP-4
■ Load balancer
Most software features that require a special feature licence are bundled into
one of the following special feature licence packs:
■ Full Layer 3 Feature Licence
■ Advanced Layer 3 Feature Licence
■ Security Pack Feature Licence
For more information about purchasing special feature licences, contact your
Allied Telesyn authorised distributor or reseller. For information on how to
enable special feature licences using the CLI, see “Enabling Special Feature
Licences” on page 20.
Warning about FLASH memory
Before you start to configure your switch, note that it is possible to enter
commands that can impact severely on your router’s performance.
DO NOT clear the FLASH memory completely. The software release files are
stored in FLASH, and clearing FLASH memory would leave no software to run
the switch.
While FLASH is compacting, do not restart the switch or use any commands
that affect the FLASH file subsystem. Do not restart the switch, or create, edit,
load, rename or delete any files until a message confirms that FLASH file
compaction is completed. Interrupting flash compaction may result in damage
to files. Damaged files are likely to prevent the switch from operating correctly.
For more information, see “How to Avoid Problems” on page 113 and “What to
Do if You Clear FLASH Memory Completely” on page 115.
To Next Page
Loading...
Need help?
General
