Translated from the original language - English - 31Manual 6-1624970M - rev. 1 - 11/01/2023
LEARNING WITH THE HIDDEN BUTTON OF A TRANSMITTER ALREADY LEARNED
NOTE
• The use of the hidden button, if present, of a transmitter already learned involves the entry in learning
mode of all the units in which it is associated. Make sure that unwanted radio controls are not learned.
• This procedure is not available for all transmitter types. Please refer to your transmitter installation manual.
When automation is stopped you can press the hidden button of a transmitter already learned to open the radio memory of the
control unit. This is equivalent to pressing the UP button on the control unit.
Then follow the learning procedure from point 3 to 5 of the previous paragraph.
CANCELLATION OF A TRANSMITTER ALREADY LEARNED BY HIDDEN BUTTON
NOTE
• This procedure is not available for all transmitter types. Please refer to your transmitter installation manual.
• After 10 seconds of inactivity the control panel leaves the learning mode and the display shows " tout ".
1.
Make sure you are out of the programming menus.
To exit, briefly press the MENU key until you see the status of the
control panel.
SS
2.
While the automation is stopped, press and release the UP button or
the hidden button of a transmitter already learned.
The word " rad "appear on the display.
SS
3.
Within 10 seconds, simultaneously press the first button and the hid-
den button of the transmitter to be deleted.
4.
If the cancellation is successful, the words " CLr " appear on the
display.
The flashing light flashes 4 times.
5.
After 2 seconds the display shows the location of the erased memory
(for example " 235 ").
To Next Page
Loading...
