0180036-J0 Rev E Page 24
• Network Telecommunication Facilities
• Locations where the NEC applies
• OSP
ATTENTION: A licensed electrician is required to install permanently wired equipment. Input voltages can
range up to 300Vdc. Ensure that the all input DC power sources to the equipment are disconnected and
locked out before performing any installation or servicing.
ATTENTION: This equipment is intended for installation in a restricted access location.
8.3 Shelf Preparation and Mounting
NOTE: The equipment shall be mounted in a clean and dry environment.
CAUTION: For the HV-ADIO a suitable enclosure must be provided around the HV wiring and modules.
8.3.1 Panel Mount
The CXC HP is capable of being panel or door mounted inside an Alpha integrated distribution center.
The preparation and mounting are done at the factory.
8.3.2 Rack Mount
The CXC HP rack mount model fits horizontally in a 19" or 23" rack. The CXC HP rack mount configu-
ration should be mounted to the rack using two #12 – 24 x 1/2" screws in each bracket. Phillips-type
screws and screwdriver should be used to eliminate the possibility of slippage and scratching of the
unit’s exterior.
8.3.3 DIN Rail Mount
The CXC HP controller and peripheral modules can be mounted onto a DIN rail with optional DIN mount
kits.
To Next Page
Loading...
Need help?
General