Never
Attempt
the
Following
Do not grip or pull out the disc while
it
is being pulled back into the
player
by
the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power
is
off.
Correct
Handling
Do not drop the disc while handling. Hold the disc so you will not
leave fingerprints on the surface. Do not affix tape, paper,
or
gummed labels to the disc. Do not write on the disc.
Inserting
Discs
Your player accepts only one disc at a time for playback. Do not
attempt to load more than one disc.
Make sure the label side
is
facing up when you insert the disc.
"ERROR" will be displayed on your player if you insert a disc
incorrectly.
If
"ERROR" continues to be displayed even though the
disc has been inserted correctly, push the RESET switch with a
pointed object such
as
a ballpoint pen.
Playing a disc while driving on a very bumpy road may result
in
skips, but this will not scratch the disc or damage the player.
New
Discs
To prevent the CD from jamming, "ERROR"
is
displayed
if
discs
with irregular surfaces are inserted or if discs are inserted
incorrectly. When a new disc
is
ejected immediately after initial
loading, use your finger to feel around the inside
of
the center hole
and outside edge
of
the disc. If you feel any small bumps or
irregularities, this could inhibit proper loading
of
the disc.
To
remove the bumps, rub the inside edge
of
the hole and outside edge
of
the disc with a ballpoint pen or other such instrument, then insert
the disc again.
CORRECT
~
~
INCORRECT CORRECT
X
0
~
~
~
~~
Disc
Accessories
There are various accessories available on the market for protecting
the disc surface and improving sound quality. However, most
of
them will influence the thickness and/or diameter
of
the disc. Using
such accessories can cause the disc to
be
out
of
standard
specifications and may create operational problems.
We
recommend not using these accessories on discs played
in
Alpine
CD players.
Disc
Cleaning
Fingerprints, dust, or soil on the surface
of
the disc could cause the
CD player to skip. For routine cleaning, wipe the playing surface
with a clean, soft cloth from the center
of
the disc to the outer edge.
If the surface
is
heavily soiled, dampen a clean, soft cloth
in
a
solution
of
mild neutral detergent before cleaning the disc.
center~Hle
New Disc
"'S
Outside
(Bumps)
~
Bumps
Center Hole
On
handling
Compact
Discs
(CD/CD-R/CD-RW)
o Do not touch the surface.
o Do not expose the disc to direct sunlight.
o Do not affix stickers or labels.
o Clean the disc when
it
is dusty.
o Make sure that there are no bumps around the disc.
o Do not use commercially available disc accessories.
Irregular
Shaped
Discs
Be
sure to use round shape discs only for this unit and never use
any special shape discs.
Use
of
special shape discs may cause damage to the mechanism.
Transparent Sheet
Disc Stabilizer
Installation
Location
Make sure this unit will not be installed
in
a location subjected
to:
o Direct sun and heat
o High humidity and water
o Excessive dust
o Excessive vibrations
Do
not
leave
the
disc in the
car
or
the
unit
for
a
long
time. Never
expose the disc to
direct
sunlight. Heat and humidity may damage
the
CD
and you may not be able to play it again.
To
customers
using
CD-R/CD-RW
o If a CD-R/CD-RW cannot
be
played back, make sure the last
recording session was closed (finalized).
o Finalize the CD-R/CD-RW if necessary, and attempt playback
again.
4-EN
To Next Page
Loading...
