EasyManua.ls Logo

Alpine CDA-105 - Installation

Alpine CDA-105
78 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Installation
Connect each input lead coming from an amplifier or
equalizer to the corresponding output lead coming
from the left rear of the CDA-105. Connect all other
leads of the CDA-105 according to details described
in the CONNECTIONS section.
Screws (M5 x 8)
(Included)
This unit
~
oo
1
00
..
tr
Front Frame
This unit
~,~/
Bracket keys
~
'l
(Included)
~
3.
Pull
the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Slide the CDA-105 into the dashboard until it clicks.
This ensures that the unit is properly locked and will
not accidentally come out from the dashboard.
Removal
1.
Remove the detachable front panel.
2.
Insert the bracket keys into the unit, along the guides
on
either side. The unit can now be removed from the
mounting sleeve.
3
Dashboard
Mounting Sleeve
(Included)
Pressure Plates"
Caution
When you install this unit in
your
car,
do not remove the
detachable
from
panel.
If
the detachable front panel is removed during installation, you
might press too hard
and
warp the metal plate that holds it in
place.
The main unit must be
moumed
within
35
degrees
of
the horizontal
plane, back to front.
1
This
unit
*
If
the illstailed mounting sleeve is loose
ill
the dashboard. the
pressure plates may be bent slightly to remedy the problem.
Remove the mounting sleeve from the main unit
(see "Removal" on page 41).
Secure the ground lead
of
the unit to a cleall metal spot using a
screw
(*3) already attached to the vehicle's chassis.
iPhoneliPod Connection (sold separately)
Connect USB cable to
an
iPhone/iPod with Interface cable for
iPod (KCU-440i, sold separately),
2
Hex Nut (M5)
Metal
Mounting
Strap
Screw
USB cable
_--a'[':i:~~,",,;]J
,t.:.,fl
e
..
~
Interface cable for iPod (KCU-440i, sold separately)
Ground Lead
Chassis
Reinforce the head unit with the metal mounting
strap (not supplied). Secure the ground lead of the
unit to a clean metal spot using a screw
(*1)
already
attached to the vehicle's chassis.
For
the
.I'crew
marked"
*2
",
use an appropriate
screwfor
the chosen
mouming location.
41-EN

Table of Contents

Other manuals for Alpine CDA-105

Related product manuals