Alpine CDA-9886M User Manual

Indication for CD Player
No Disc
• No CD is inserted.
o Insert a CD.
• Although a disc is inserted, "No Disc" is displayed and the unit
does not start to play or eject the disc.
o Remove the disc by following these steps:
Press the ~ button again for at least 2 seconds.
If the disc still does not eject, consult your Alpine dealer.
Error
Error 02
• A disc is left inside the CD Changer.
- Press the eject button to activate the eject function. When the
CD Changer finishes the eject function, insert an empty CD
magazine into the CD Changer to receive the disc left inside
the CD Changer.
No Magazine
• No magazine is loaded into the CD Changer.
o Insert a magazine.
No Disc
• Mechanism error.
1) Press the ~ button and eject the CD.
If not ejecting, consult your Alpine dealer.
2) When the error indication remains after ejecting, press the ~
button again.
If the error indication still does not turn off after pressing the
~ button for a few times, consult your Alpine dealer.
• No indicated disc.
o Choose another disc.
Indlcatlol'lfor;SAT·ReceiverMQdel ...
..
.. ;~'.- . .;' ..
• Whell" Error" is displaved:
Il'the disc call1lot be ejected by pressing
~. press the RESET switch
(refer
10 page 7) and press ~ again.
If the disc still connot be ejected. consult yourAlpine dealer.
PROTECT
• A copy-protected WMA file was played back.
o You can only play back non-copy-protected files.
I UNSUPPORTED I
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
ANTENNA
• The XM or SIRIUS antenna is not connected to the XM or
SIRIUS radio module.
- Check whether the XM or SIRIUS antenna cable is attached
securely to the XM or SIRIUS radio module.
I UPDATING I
• Radio is being updated with latest encryption code.
o Wait until encryption code is being updated. Channels 0 and I
should function normally.
• XM or SIRIUS signal is too weak at the current location.
o Wait until the boat reaches a location with a stronger signal.
Indicatlonfor'CDc:hangtlr'
High Temperature
• Protective circuit is activated due to high temperature.
o The indication will disappear when the temperature returns to
normal operating range.
INO SIGNAL I
I Acquiring Signal I
(XM mode)
(SIRIUS mode)
LOADING
• Radio is acquiring audio or program information.
- Wait until the radio has received the information.
• The channel currently selected has stopped broadcasting.
- Select another channel.
Error 01
• Malfunction in the CD Changer.
- Consult your Alpine dealer. Press the magazine eject button and
pull out the magazine.
Check the indication. Insert the magazine again.
If the magazine cannot be pulled out, consult your Alpine
dealer.
• Magazine ejection not possible.
o Press the magazine eject button. If the magazine does not eject,
consult your Alpine dealer.
40-EN
OFF AIR
Acquiring Signal
(XM mode)
(SIRIUS mode)

Alpine CDA-9886M Specifications

General

Brand	Alpine
Model	CDA-9886M
Category	Car Receiver
Language	English