2 Set discs
in
the disc tray with the labeled side
facing up. Set one disc
in
the tray
at
a time (up to 6
discs).
Be careful not to drop the disc.
After loading the discs, push the disc tray fully into
the magazine until it closes and a click is heard.
1 Grasp the sliding door knob and slide the door
fully to the right.
2 Press the eject button to eject the magazine, then
remove the magazine.
Eject
button
3 Pull the tray removal knob with your finger and
draw the disc tray out of the magazine.
Pay attention to the disc's signal surface when
removing discs. (See "PRECAUTIONS" on
page 4.)
Tray removal
knob
Magazine
4 Make sure the magazine is
in
the proper direction
(toplbottom and front/back), then push it in fully
until a click Is heard and the magazine is locked
in
place.
3 Grasp the sliding door knob and slide the door
fully to the right.
5 After inserting the magazine, grasp the tab of the
sliding door and slide the door all the way to the
left until it locks with a "click".
• When the magazine
is
inserted, a check
of
the disc inside the magazine is
peljomled
automatically.
• Do not remove the disc tray from the magazine.
When the disc tray is pulled outfrom the magazine, do not pull it out
with excessiveforce. Doing so will cause breakdown.
Cautions
on
using
the
magazine
• This product's magazine is used exclusively for this
product. CD changer magazines (included magaZines or
accessories) cannot be used with this product.
• Disc trays for CD changer magaZines cannot be used with
this product's magazine. Such trays can be inserted for
reasons of structure, but using them may damage this
product. Never use disc trays for
CD
changer magazines.
• Do not forcibly remove the magaZine.
• Only one disc can be inserted per tray. Attempting to insert
two
or
more discs will result in damage.
• Never remove the tray from the magaZine.
• Even when the ignition key is set to
OFF,
the magazine
can be removed.
8.EN
To Next Page
Loading...
