In
Case
01
Omiculty
If
you encounter a problem, please turn the power off, then on again.
If
the unit is still not functioning normally, please review the items in
the following checklist. This guide will help
you
isolate the problem
if
the unit is at fault. Otherwise, make sure the rest
of
your system is
properly connected or consult your authorized Alpine dealer.
No function or display.
o Vehicle's ignition is off.
-
If
connected following the instructions, the unit will not
operate with the vehicle's ignition off.
o Improper power lead connections.
-
Check
power lead connections.
o Blown fuse.
- Replace the fuse
on
the battery lead
of
the unit with the
proper value.
Unable to fast forward
or
reverse the disc.
o
The
disc has been damaged.
- Eject the disc and discard it; using a damaged disc in your
unit
can
cause
damage to the mechanism.
Disc playback sound skips due to vibration.
o Improper mounting
of
the unit.
- Securely re-mount the unit.
o Disc is very dirty.
- Clean the disc.
o Disc has scratches.
- Change the disc.
o
The
pick-up lens is dirty.
-
Do
not use a commercial available lens cleaner disc.
Consult your nearest ALPINE dealer.
Disc playback sound skips without vibration.
o Dirty
or
scratched disc.
- Clean the disc; damaged disc should
be
replaced.
CD-R/CD·RW playback not possible.
o Close session (finalization) has not been performed.
- Perform finalization and attempt playback again.
Error displays
o Mechanical error
- Press
~.
After the error indication disappears, insert the
magazine again.
If
the above-mentioned solution does not
solve the problem, consult your nearest
ALPINE
dealer.
MP3IWMAlAAC is not played back.
o Writing error occurred.
The
CD
format is not compatible.
- Make sure the
CD
has been written in a supported format.
Refer to "About
MP3IWMN
AAC"
on
pages 17-18, then
rewrite in the format supported by this device.
Unit does not operate.
o Monitor's power is not turned on.
- Turn
on
the monitor's power.
o Condensation.
- Wait a while (about 1 hour) for the condensation to dry.
No
picture is produced.
o Monitor's mode is not switched to the mode you want to see.
- Switch to the
mode
you want to see.
o Monitor's parking brake cord is not connected.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
o Monitor's parking brake is not set.
- Connect the monitor's parking brake cord and set the parking
brake. (For details, refer to the monitor's instructions.)
Playback does not start.
o Disc is loaded upside-down.
- Check the disc and load it with the labeled side facing upward.
o Disc is dirty.
- Clean the disc.
o A disc not able to playback with this unit is loaded.
- Check
if
the disc is able to
be
played back.
o Parental lock is set.
- Cancel the parental lock
or
change the rating level.
o Setup menu is displayed.
- Press and hold
SETUP for at least 2 seconds to turn the
menu off.
Picture is unclear
or
noisy.
o Disc is being fast-forwarded
or
fast-reversed.
-
The
picture may be unclear, but this is normal.
o Vehicle's battery power is weak.
-
Check
the battery power and wiring.
(The unit may malfunction
if
the battery power is under
11
volts with a load applied.)
o Monitor's fluorescent tube is worn out.
- Replace the monitor's fluorescent tube.
Unable to turn the power off by switching sources on
the head unit. (Only when an Ai-NET compatible (AV)
head unit is connected.)
o
The
switched (ignition) power lead for this unit is connected.
-
Do
not connect the switched (ignition) power lead for this
unit when an Ai-NET compatible (AV) head unit is
connected.
Playing back a DRM protected
DivX®
File
Some operations cannot be performed while displaying the following
message.
"Authorization Error"
o
If
a non-approved
DRM
protected
DivX""
file that does not
comply with the registration code
of
the unit is played back,
"Authorization Error" is displayed for 2 seconds, meaning the
file cannot
be
played back. After the message has been
displayed, the beginning
of
the next file will automatically
be
played back.
"Rental Expired"
o There is a rental file in the
DivX@
that is set to audio/visual
times.
If
audio/visual time is counted as 0, "Rental Expired" is
displayed for 2 seconds, indicating that the file cannot
be
played back. After the message has been displayed, the
beginning
of
the next file will automatically be played back.
"Rental countdown OK?"
o While playing back a rental file,
if
B.SKIP
or
ENTER
in the
file selection menu is selected, "Rental countdown
OK?"
is
displayed, and the rental file playback is interrupted (audio/
visual times are reduced by 1).
The
file has paused (PAUSE)
at
the time. To interrupt the playback, select [YES],
or
select
[NO] to not
be
interrupted.
"This rental has (remaining times) views left.
View
DivX®
VOD Rental?"
o
If
audio/visual times still remain, the remaining number
of
playback times is displayed. To play back, select [YES).
If
the
next file is to be played back, select [NO).
33.EN
To Next Page
Loading...
