Getting
Started
2 Replacing the battery.
Put the battery
in
the case with the (+) indication upward
as shown
in
the illustration.
3 Closing the cover.
Slide the cover
as
illustrated until a click
is
heard.
• Placing a
battery
in backwards
way
may
cause
a ma(function.
Iitt---
Numeric
keypad
(1
to
6)
DISC'"
-----lKK::J
DISC T
-----If+K::J
PWR
--t1t-E::J
FOLDER
ON
--Hf-E~~~9:::m=::::
~OLDER
UP
LIST
----+;~...J
ENT. ----;-\\-:::::::
When
Using
the
Remote
Control
• Point the remote
control
at the remote
sensor
within
about
2 meters.
•
It
may
not
be
possible
to
operate
the
remote
control
If
the
remote
control
sensor
is
exposed
to
direct
sunlight.
• The remote
control
is
a small,
lightweight
precision
device.To avoid damage,
short
battery life,
operational errors and
poor
response, observe the
following.
- Do
not
subject
the remote control
to
excessive
shock.
- Do
not
put
in
a
trouser
pocket.
- Keep away
from
food, moisture and dirt.
- Do
not
place in
direct
sunshine.
Battery
Replzcement
Battery type: CR2025 battery or equivalent.
Lt
Warning
DO
NOT OPERATE ANY FUNCTION THAT TAKES
YOUR
ATTENTION
AWAY
FROM SAFELY DRIVING
YOUR
VEHICLE.
Any function that requires your prolonged attention should
only be performed after coming to a complete stop. Always
stop the vehicle
in
a safe location before performing these
functions. Failure to do
so
may result
in
an
accident.
1 Opening the battery case.
Slide out the battery cover while firmly pressing
in
the
direction of the arrow.
Handling
the
Magazine
Turn on the power before loading and unloading discs. (Refer to
''Turning Power On and
Off'
on page 9.)
1 Pull the tray removal knob with
your
finger
and
draw
the
disc
tray
out
of
the magazine.
Be careful
not
to
drop
the disc.
Magazine Tray removal knob
• Do not remove the disc tray from the magazine.
When the disc tray is pulled outfrom
rhe
magazine. do not pull
ir
our
wirh
excessive force. Doing so will cause breakdown.
7-EN
To Next Page
Loading...
