Installation
Erectio n gen eral p rocedu res
T31--003EN/01
3/6
09--1998
E ALSTOM
Screw sealing
Introduction
To prevent humidity from penetrating SF
6
gaskets, the outer mounting screws
should be sealed by applying an appropriate product.
NOTE
: This procedure should be applied to all assemblages of parts
submittedtoSF
6
pressure and electrical connection assembling.
Necessary products
List of the ALSTOM products and accessories necessary for the screw seal-
ing :
ALSTOM
reference
Diagram Designation
--01818327 LOCTITE 225 (250ml)
--01835265 MOLYKOTE 111 (100g tube)
--01835118 CONTACTAL HPG (200g tube)
Choice of the
product to use
The table below gives the product to use for the screw sealing depending on
the assembling type :
If assembling... Product to use ...
Can be
dismantled ?
Product ...
with seals
YES MOLYKOTE 111
NO LOCTITE 225
electrical connections CONTACTAL HPG
Continued on next page.
To Next Page
Loading...
