TRANSMISSION & DISTRIBUTION
High voltage switchgear
SAFETY SHEET
PS 0008/A 03 G. BERNARD
1998-08-12
P. VANDAME
98.08.28
1 / 2
Sheet N° Revision Written by Date Signature Approved by Date Signature Page
OPERATION
CAUSE OR ORIGIN OF HAZARD.
If the unit shows any sign of an unwanted condition, it must be examined by the user.
WORK REQUIREMENTS.
The operators concerned must be suitably qualified and must comply with the normal operating and
maintenance instructions issued by ALSTOM
.
Depending on the severity of the fault observed, the necessary corrective measures must be taken, e.g :
- replenish the SF
6
gas in the event of a leak,
-
isolate the system in the event of a major malfunction
.
SAFETY INSTRUCTIONS.
OBSERVE ALL GENERAL INSTRUCTIONS GOVERNING INSTALLATION, COMMISSIONING AND
OPERATION IN ACCORDANCE WITH CURRENTLY ACCEPTED PRACTICES AS WELL AS THOSE LAID
DOWN IN THE DOCUMENTATION SUPPLIED WITH THE EQUIPMENT.
To Next Page
Loading...
