www.alstor.se | 3
Instruction manual
INTRODUCTION
822/834/850/850 H/851
INTRODUCTION TO THIS INSTRUCTION MANUAL
This instruction manual is for the Alstor 8×8.
This instruction manual covers several models. In the heading at the top of each page , you will nd the model to which this page refers.
NOTE: The pages in the instruction manual may apply to one or several models.
The information in this instruction manual is provided for the safe and ecient use of the machine. Never exceed the maximum power
levels and capacities and do not use the machine for any other purpose than what is indicated. The manufacturer’s warranty only applies
as long as the manufacturer’s instructions are carefully followed.
We recommend all users of the machine to carefully read and understand these instructions.
It is the responsibility of the users to familiarise themselves with the correct use of the machine and to always follow the instructions.
Never allow anyone else to operate the machine unless the operator has the requisite competence and experience and has carefully read
and understood the operating instructions and safety precautions for this Alstor machine. Upon delivery of the product, be sure to check
that all parts are free from transport damage. If damage is detected, please notify the dealer immediately.
Alstor AB reserves the right to make changes to the equipment, maintenance instructions and specications without prior notice.
The EU Declaration of Conformity with the Machine Directive 2006/42/EC is attached as an appendix at the end of this instruction manual.
This is atranslation of the original operating instructions in Swedish.
Manufacturer: Dealer:
ALSTOR AB
Åkarevägen 4
SE-455 97 Dingle, Sweden
Tel.: +46 (0) 524-407 45
info@alstor.se
www.alstor.se
This instruction manual constitutes an integral part of the machine and must be included with the machine in the event
of achange in ownership.
No part of this document may be copied or transferred without written permission.
To Next Page