www.alstor.se | 7
822/834/850/850 H/851
Instruction manual
SAFETY
1.1 GENERAL SAFETY PRECAUTIONS
Prior to operating the Alstor 8×8, carefully read all precautions in this instruction manual. It is imperative that the operator is completely
familiarised with the machine for its correct use. Injuries and damage to the machine can be prevented through correct use. Incorrect use
can give rise to injuries and damage to the machine and other property.
Any modication that aects the performance or safety of the machine may only be performed by Alstor AB or by personnel duly
authorised by Alstor AB.
The removal or deactivation of safety devices, safety alerts and safety covers on the machine is absolutely prohibited.
The term “Operator” in this instruction manual refers to persons with the necessary experience, knowledge and technical skills to drive,
operate and maintain the Alstor machine or related equipment. The term “Machine” in this instruction manual refers to the Alstor 8×8.
This warning symbol serves to alert the operator to very important safety information.
There is apotential risk of injury or death to humans and damage to the machine.
Important! When the machine is used in conjunction with acrane, the accompanying crane instruction manual must be followed.
Furthermore, also carefully heed the engine instruction manual. This is attached as an annex in the document binder.
In addition to this instruction manual, local laws and regulations concerning safety, health and environmental regulations must
beobserved.
It is important that the machine operator becomes familiarised with and competent in handling the machine.
It is not possible to warn of all possible risks and safety hazards, and with this in mind we urge the operator to act carefully and exercise
sound judgement. This includes taking preventive safety precautions, and observing the instructions with regard to machine safety,
placement of instruments and controls, safe braking and handling of ammable liquids. Learn how the machine operates, practice
driving and operating the machine before taking it o-road. Be aware of the extended hazardous area involved when felling trees. You
must never access this area while the machine is in operation. Current driving license requirements must be adhered to. Please check the
regulations that apply in the country of use. In order to drive alight o-road vehicle in Sweden, the operator must have aclass B driver’s
license qualication.
Only persons (operators) fully familiar with the machine and who possess the necessary technical skills are allowed to operate, service,
repair and drive the machine. The machine operator must never be under the inuence of alcohol, medicine or drugs. During operation,
only one person is allowed in the vehicle. It is prohibited to have passengers in the vehicle, including children on your lap, when handling
and operating the machine. Never set the machine in motion, unless properly seated on the operator’s seat. Important data that applies
to your machine can be found in the technical data section of this instruction manual.
WARNING! The safety area is 50 metres. Do not allow any bystanders within this safety area.
The operator must have full visual control of the work area. Negligence can result in immediate danger to life.