ALSTOR 822 - Overturned Machine; Machine Storage

www.alstor.se | 35
822/834/850/850 H/851
Instruction manual
SERVICE AND MAINTENANCE
Make sure that cigarettes, sparks and open ames are kept away from all petroleum products. There is arisk of re.
When working on the electrical system, be sure to disconnect the battery cables from the battery.
Remove the battery before carrying out any welding work. Batteries produce explosive hydrogen gas during charging. Sparks or an open
ame can give rise to explosions with arisk of serious injury.
Prior to repairing hydraulic components, make sure the hydraulic system has been depressurised. Be diligent and wear personal protective
equipment, since hot hydraulic oil can easily penetrate the skin.
The person responsible for the service work should check and ensure that all repair work has been done properly and that allsafety
devices operate correctly.
3.2 IF YOUR MACHINE HAS OVERTURNED
If only the rear section has overturned, it is possible to return it to its upright position by using the outriggers and possibly the crane.
Carefully check that nothing has been damaged. If nothing has been damaged, continue with your journey/work as normal.
WARNING! Immediately switch o the engine if the front section has overturned. Do not attempt to start the machine before
checking for fuel leaks. Fuel leakage can cause are.
Tilt the machine back in an appropriate manner. If the front section has overturned, request an inspection from an authorised workshop
before using the machine again. Crucial functions may have suered damage, which in the worst case can lead to engine failure. If the
front section has been lying on its side, check for oil leaks above the pistons before attempting arestart.
We recommend that aknowledgeable workshop checks the operation of the engine, possibly loosening the injector nozzles and running
anumber of revs with the starter motor so that any oil is ejected and then reinstalling the parts.
Be diligent and wear personal protective equipment, since hot hydraulic oil can cause serious injury.
3.3 LONG-TERM MACHINE STORAGE
If the machine is not going to be used for along period of time, we recommend careful inspection to assure normal operation during
subsequent commissioning and use.
We recommend the following preparations prior to long-term storage:
Drain the fuel
Change the engine oil and lter
Fill the cooling system to the correct level
Remove the battery and charge it regularly. For additional battery information, please refer to the chapter on service and maintenance/
battery.
Store the machine within the indicated temperature range and out of direct sunlight. If the machine is going to be covered, avoid plastic
covers and other tight materials that prevent air ow and collect moisture.