ALSTOR 822 - Page 50

50 | www.alstor.se
Instruction manual
SERVICE AND MAINTENANCE
850/850 H
Remove and install the undercover.
■
Remove by loosening 4×2 screws (1) on the left and right sides.
■
Reinstall by replacing all 8 screws.
Engine oil
Remove the undercover according to the instructions.
Unscrew the drain plug (6).
Drain the engine oil by opening the cock (5).
Refer to the engine instruction manual for lter replacement and
lling of oil.
When replacing the engine oil, the lter should always be replaced.
The engine oil quality is important for both engine power and
engine service life.
Always use the recommended oil grade and oil lters.
Check, replenish or replace the oil regularly at the recommended
intervals. See the table on page 42.
1
5
6
3.7 INSTRUCTIONS FOR OIL/FILTER REPLACEMENT, 850/850 H
Always take used oils/waste to the local waste collection facility for recycling.
WARNING! Always wear personal protective equipment when handling oils. Oils can be corrosive to the skin. Oils in awarm
machine can be extremely hot. Risk of injuries from burns.
Transfer box oil
Place asuitable vessel for oil drainage under
the machine, and open the bottom plug (2)
and drain the oil. Screw the bottom plug
back in.
Tilt the cabin. See the instructions on
page49.
Open the oil ller plug (4) and, if necessary,
also the level plug (3).
Fill up with 0.4 L of new oil.
Tighten the oil ller plug and the level plug.
Tilt the cab back.
3 42 2