SR1128 operation manual
~14~
--------------------------------------------------------------------------------------------------------------------------
►Press “+” button, “tH 3o 17:00” displays on the screen, to access the submenu of the
switch-on time and temperature for the third schedule of heating function.
► Press “SET” button again, “17” of hour time blinks
on screen.
►Press “+” “-” button to adjust hour of time.
►Repress “SET” button again, “00” of minute time
blinks on screen.
►Press “”“”button to adjust minute of time.
►Repress “SET” button, temperature “50ć” blinks on screen.
►Press “”“”button, to set the switch-on temperature of heating.
►Then, press “ESC” to exit this submenu.
►Press “+” button, “tH 3F 22:00” displays on the
screen, to access the submenu of the switch-off time
and temperature for the third schedule of heating
function.
► Press “SET” button again, “22” of hour time blinks on screen.
►Press “+” “-” button to adjust hour of time.
►Repress “SET” button again, “00” of minute time blinks on screen.
►Press “”“”button to adjust minute of time.
►Repress “SET” button, temperature “55ć” blinks on screen.
►Press “”“”button, to set the switch-off temperature of heating.
►Then, press “ESC” to exit this submenu, or wait for 20 seconds to exit automatically, the
parameter valves are saved automatically.
--------------------------------------------------------------------------------------------------------------------------
Note: when no gas or oil boiler is connected to solar system, electrical heater can be
installed as back-up device, when electrical heater is in operation status, signal blinks
on screen, and LED light is on.
Application sample:
1 2 3
To Next Page
Loading...