INSTALLATION
Del uxe Control C ook & Ho l d ▪ Opera tor’s Manual ▪ MN- 4 6708 ▪ Re v 1 ▪ 11/20
30
Continued from previous page
Electrical connection
Continued on next page
WARNING: Appliances without a cord provided by the factory
must be equipped with a cord of sufficient length to permit the
appliance to be moved for cleaning.
Always use the correct AWG wire size based on the electrical
requirements for the appliance.
WARNING: To prevent serious injury, death, or property
damage:
All electrical connections must be made by a qualified and
trained service technician in accordance with applicable electrical
codes.
This appliance must be adequately grounded in accordance with
local electrical codes or, in the absence of local codes, with the
current edition of the National Electrical Code ANSI/NFPA No 70.
In Canada, all electrical connections are to be made in
accordance with CSA C22 1, Canadian Electrical Code Part 1 or
local codes.
CE-approved appliances include an equipotential-bonding
terminal marked with the equipotential symbol. Provisions for
earthing are to be made in accordance with IEC:2010 60335-1
section 27 or local codes.
CAUTION: Electrical shock hazard.
Power source must match voltage identified on appliance rating
tag. The rating tag provides essential technical information
required for any appliance installation, maintenance or repairs
Do not remove, damage or modify the rating tag.
To Next Page
Loading...
