MAINTENANCE
Del uxe Control C ook & Ho l d ▪ Opera tor’s Manual ▪ MN- 4 6708 ▪ Re v 1 ▪ 11/20
86
Continued from previous page
▪ Check and tighten the cord connection inside of the appliance control area.
▪ Inspect the control cooling fans (if applicable).
▪ Measure the site voltage.
▪ Inspect and adjust voltage monitor board if needed.
▪ Inspect and test the product probe and product probe receptacle.
▪ Inspect and test the control and control functions.
▪ Inspect the cavity for structural integrity.
▪ Inspect the door gaskets for correct shape and seal. Replace/repair as needed.
▪ Inspect the door handle and hinges. Replace/repair as needed.
▪ Inspect the full perimeter bumper.
▪ Inspect the casters.
▪ Do a cavity temperature calibration procedure per manufacturer’s
recommendations.
To Next Page
Loading...
