MAINTENANCE
Converge® ▪ Operator’s Manual ▪ MN-47239 ▪ Rev 3 ▪ 5/23
102
Continued from previous page
5. Touch “Ok” 3 when the catalyst wash cycle is complete.
6. Clean the door glass with Windex® or equivalent glass cleaner.
7. Clean the door gasket with soap and water.
8. Spray the exterior of the oven with stainless steel polish. Wipe the exterior of
the oven with a non-abrasive scrub pad. Follow safety instructions on the
bottle of the stainless steel polish.
9. Leave the door slightly ajar if the cleaning has been done at the end of the
day.
Result The oven is now clean.
WARNING: Burn hazard.
Open the door carefully when the catalyst wash cycle
is complete. Escaping hot vapors or steam can cause
injury.
NOTICE
Use only non-caustic cleaners.
Do not spray directly into the fan openings on the
rear of the oven.
Do not use cleaners that contain sodium hydroxide
(lye) or phosphorus.
CT-TS-015582
03:44:15
Catalyst Wash program
finished. Leave door slightly
ajar.
e
To Next Page
Loading...
