3
Always transport the unit upright; laying the unit on its side
or top during transit may cause equipment damage. The
installer should inspect the product upon receipt for shipping
damage and subsequent investigation is the responsibility
of the carrier. The installer must verify the model number,
specications, electrical characteristics, and accessories are
correct prior to installation. The distributor or manufacturer
will not accept claims from dealers for transportation damage
or installation of incorrectly shipped units.
2.1 Parts
Inspect the unit to verify all required components are
present and intact. Report any missing components
immediately to or to the distributor. Use only factory au-
thorized replacement parts (see Section 4). Make sure to
include the full product model number and serial number
when reporting and/or obtaining service parts.
2.2 Handling
Use caution when transporting/carrying the unit. Do not
move unit using shipping straps. Do not carry unit with
hooks or sharp objects. The preferred method of carrying
the unit after arrival at the job site is to carry via a two-
wheel hand truck from the back or sides or via hand by
carrying at the cabinet corners.
This product is designed and manufactured to comply with
applicable national codes. Installation in accordance with
such codes and/or prevailing local codes/regulations is the
responsibility of the installer. The manufacturer assumes no
responsibility for equipment installed in violation of any codes
or regulations.
Operating conditions:
150° F max and 40° F min ambient surrounding cabinet for
cooling mode.
90° F max and 0° F min ambient surrounding cabinet for
heating mode.
-
troduction and disposal of refrigerants. Failure to follow
these regulations may harm the environment and can
Should you
have any questions please contact the local oce of the EPA
and/or refer to EPA’s website www.epa.gov.
When reporting shortages or damages, or ordering repair
parts, give the complete product model and serial numbers as
stamped on the product. Replacement parts for this product
are available through your contractor or local distributor. For
the location of your nearest distributor consult the white busi-
ness pages, the yellow page section of the local telephone
book or contact:
HOMEOWNER SUPPORT
DAIKIN COMFORT TECHNOLOGIES NORTH AMERICA, INC.
190001 KERMIER ROAD
WALLER, TEXAS 77484
855-770-5678
5.1 Preparation
Keep this document with the unit. Carefully read all in-
structions for the installation prior to installing product.
Make sure each step or procedure is understood and
any special considerations are taken into account before
starting installation. Assemble all tools, hardware and
supplies needed to complete the installation. Some items
may need to be purchased locally. Make sure everything
needed to install the product is on hand before starting.
5.2 System Matches
The entire system (combination of indoor and outdoor
sections) must be manufacturer approved and Air-
Conditioning, Heating, and Refrigeration Institute
(AHRI) listed. Installation of unmatched
systems is not permitted. Damage or repairs due to
installation of unmatched systems is not covered under
the warranty.
-
-
WARNING
WARNING
-
To Next Page
Loading...
Need help?
General
