15
Backwall
1. See Figure 23. Remove screw in front of blower
transition separating blower transition from blower
housing.
2. Place hose clamp around round end of blower
transition and attach flex duct to blower transition
using hose clamp.
A
C
B
D
A—Blower and transition piece
B—Hose clamps
C—Flex duct
D—Thimble
Figure 23
3. Place long end of thimble into wall and secure
thimble using four screws provided, one in each
corner.
4. Place hose clamp provided around short end of
thimble. Attach opposite end of flex duct to short
end of thimble using hose clamp.
5. Connect electrical supply.
6. Carefully push range back into position. Avoid
pinching transition piece or flex duct.
7. Using guide screw to locate hole in rear of blower
housing position transition inside blower housing.
Rotate transition until hole in front of blower housing
is aligned. Secure transition with screw provided.
8. Seal all duct joints with duct tape.
9. Check under range to be sure leveling leg is fully
engaged in the anti-tip bracket.
10. Install storage drawer.
3. See Figure 22. Insert floor plate into elbow duct and
attach using 2 screws provided.
• Tighten only front screw.
• When installed, wide flange of floor plate must face
toward back of range.
A
B
C
D
E
A—Blower
B—Floor elbow duct
C—Floor plate
D—Transition piece and gasket
E—Blower transition
Figure 22
4. Remove blower transition from blower.
5. Attach floor elbow duct to blower using 2 screws
provided.
• Floor elbow duct should be inside blower.
6. Connect electrical supply.
7. Push range into position.
• Tilt range slightly while pushing in range. Tilting
range allows floor plate to clear gasket.
• Make sure that floor elbow duct is directly over
transition piece and rubber gasket.
• Rubber gasket provides a seal between floor elbow
and transition piece. See figure below.
To Next Page
Loading...
Need help?
General
