３５
5. Maintenance (continue)
Be sure to read and understand on the page 3 to 7 “For safety operation” carefully before use
Inspection of the eliminator
Import
ant
●The metallic side plates are very slippery due to oil on their surfaces. So, please be very careful not to cut
your finge
rs etc. on the edges at bends in
them.
●T
o work with the collecting unit, use appropriate protective wear.(such as rubber gloves, protec
tive
glasse
s), and devices
.
●Befo
re opening the inspection door or electrical equipment cover, turn off the power supply
to the mist
colle
ctor.
●In order to operate the mist collector at the designed performance, install all collecting units corre
ctly
(su
ch as eliminator and electrodes.)
●Be sure to use Amano's genuine parts of collecting unit. The collecting unit for other model cannot
be
us
ed for this mist collector.
●
1 Opening the inspection door
Unscrew the hexagon bolt fixed inspection door and open the inspection door.
●
2 Pulling out the eliminator
Pull out the eliminator .
●
3 Inspecting the eliminator
Check it for contamination, deformation and breakage. If the contamination is at unallowable level, clean the
eliminator following the procedure given in the next section. If any deformed or broken part is detected,
replace the eliminator with a new one.
●
4 Installing the eliminator and shutting the inspection door
To reinstall the eliminator, face it as illustrated at right and slowly draw it in along guides on the internal walls
of the main unit.
If the specification of opposite direction of airflow, the insertion
direction is also opposite.
Caution
Insertion direction o
Grip
To Next Page
Loading...