Amano EM-e II - For Safety Operation (Continue); Operational Parameters and Limitations

６
1．For safety operation(continue)
Operate the product safely and according to directions to help ensure it delivers maximum performance.
Adjust the use environment temperature in the range from 0°C to 40°C.
Failure to do so could cause malfunction.
CAUTION
Adjust the temperature of the sucked air to come in the range from 0°C to 40°C.
Failure to do so could cause trouble and malfunction
Never allow the following substance to go into the mist collector.
・abrasion substance。
・Other: liquid such as w
ater.
Failure to do so could cause malfunction.
Never turn on the switch with the inspection/electric part door opened.
Failure to do so could cause trouble or injury.
Do not repeat fully opening and closing the ports.
Failure to do so could cause malfunction.
Do not operate without charging/collecting electrodes.
Failure to do so could cause malfunction.
Be sure to operate the mist collector at the appropriate airflow rate EM-15eII: 15 m
3
/min,
EM-30eII: 30 m
3
/min
Do not use the mist collector in a surging range. EM-15eII: Below 12.5 m
3
/min, EM-30eII:
Below 25 m
3
/min
Oil mist ma
y
leak from the exhaust
p
ort or the collector ma
y
break down.
Keep the pH of the sucked oil mist in the range from pH 7.0 to 10.5.
Failure to do so could cause trouble and malfunction
Be sure to use as appropriate motor rotation.
Failure to do so could cause malfunction.
The electrical conductivity of the oil mist should be below 300 mS (millisiemens)/m.
Failure to do so could cause a machine failure.
The concentration of oil mist to be suctioned should be below 200 mg/m3.
Oil mist may leak from the exhaust port or the collector may break down.