14
EN
Changing Batteries
WARNING
Risk of electric shock!
Disconnect the product from any circuit, remove
the connector leads (N) from the input jacks (F)/(G)/
(K)/(L), and turn OFF the product before opening
the battery compartment (R). Do not operate the
product with an open battery compartment.
NOTICE
Replace the battery when the low
battery indicator (4) is shown on the display (A).
• Open the tilt stand (S).
• Loosen the screw of the battery compartment
cover (R) and remove it.
• Insert a 9 Vbattery and attach it to the snap
connector.
• Place the battery in the battery compartment(R).
• Close the battery compartment (R) and tighten
the screw.
Operation
NOTICE
Keep the protection plugs of the
connector leads and reattach after use.
Switching the product on/off
• To switch the product on, set the function
switch (E) to the desired measurement mode.
To Next Page
Loading...
