26
EN
• The stabilized value on the display (A) is read as
the actual reading.
Resistance measurement
WARNING
Risk of electric shock! To avoid
electric shock, disconnect power from the unit
under test and discharge all capacitors before
taking any resistance measurements. Remove the
batteries or unplug. Resistance measurements are
taken with no electricity running in the circuit.
NOTICE
For best results, disconnect one
side of the component under test. This is to avoid
the other components in the circuit inhibiting the
measurement.
• Set the function switch (E) to the Ω CAP
position.
• Insert the black connector lead (N) into the
negative COM input jack (L).
To Next Page
Loading...
