33
EN
• Place the thermocouple probe tip to the
component under test.
• The stabilized value on the display (A) is read as
the actual reading.
NOTICE
For longer period of measurements,
use a thermal tape to attach the thermocouple
probe to the surface being measured.
NOTICE
Risk of product damage!
Disconnect the thermocouple probe (Q) before
changing to other electrical measurement mode.
Cleaning and Maintenance
NOTICE
Switch the product off and all the
connector leads before cleaning.
NOTICE
During cleaning do not immerse the
product in water or other liquids. Never hold the
product under running water.
Cleaning
• To clean the product, wipe with a soft, slightly
moist cloth.
• If necessary, clean the input jacks (F)/(G)/(K)/(L),
and all connectors with a soft brush.
• Never use corrosive detergents, wire brushes,
abrasive scourers, metal or sharp utensils to
clean the product.
To Next Page
Loading...