32
EN
• The stabilized value on the display (A) is read as
the actual reading.
Temperature measurement
• Insert the thermocouple probe adapter (P) with
the black connector into the negative COM
input jack (L) and with the red connector into
the positive input jack (K).
• Connect the thermocouple probe (Q) to the
thermocouple probe adapter (P). The polarity
marking of the probe (Q) must correspond to
the marking of the adapter (P). The probe pins
are made in varying sizes to avoid a wrong
connection.
• Set the function switch (E) to the TEMP °C °F
position.
• Press the MODE button (D) to change the
temperature unit.
To Next Page
Loading...
