30
EN
• Set the function switch (E) to the Ω CAP
position.
• Insert the black connector lead (N) into the
negative COM input jack (L).
• Insert the red connector lead (N) into the
positive input jack (K).
• Press the MODE button (D) 3 times to switch
to capacitance measurement mode. nF should
light up as the unit(2).
• Place the test probes (N) across the capacitor
under test.
• The stabilized value on the display (A) is read as
the actual reading.
NOTICE
The test may take up to 3 minutes or
more for large capacitors to charge.
To Next Page
Loading...
