Amazone AMADOS+ - Operation of the AMADOS* Computer; AMADOS* On-;off Switching; Entering Implement Specific Data

12
Operation
AMADOS
+
DB 1001 01.04
4. Operation
4.1 AMADOS
+
On-/off switching
By pressing key den AMADOS
+
is switched on
and off.
F
When switching on, the display shows
the creation date of the computer pro-
gram for some seconds.
I
Always ensure th
at the setting motors
set the setting levers nearly into the
range of the zero-
position (do not mind
scales).
F
Whenever the supply voltage drops to
below 10 volts, e. g. when starting the
tractor, the computer automatically
switches off. It has to be swit
ched on
again as described above.
4.2 Entering the implement specific data
The implement specific entering values required by
AMADOS
+
are dialled directly
- dialled via the keys or. or
- determined by a calibration procedure.
F
When dialling the entering valu
es the
display jumps into the desired direction
by one step forward or backward by the
first pressure onto key or
By repeated pressure onto the key the
display continues to run until the key is
released.
I
All via the keys
or
dialled
or determined
by a calibration procedure
entering values must always be con-
firmed by pressing key
and be
stored this way..
I
Before starting to operate enter the im-
plement specific data by pressing the
corresponding keys in the mentioned
order newly or check or de
termine by
carrying out a calibration procedure.
F
Already entered implement specific data
remain stored.
a
AMADOS
+
has not been designed for the
application of slug pellets or fine seeds.