Amazone AMADOS+ - Determining the Fertilizer Calibration

16
Operation
AMADOS
+
DB 1001 01.04
4.2.5 Determining the fertilizer calibration
The fertilizer calibration factor determines the control-
ling behaviour of AMADOS
+
and depends on
• the flowing behaviour of the fertilizer to be spread.
• the entered spread rate.
• the entered working width.
The fertilizer flowing behaviour itself depends on
• the fertilizer storing, the fertilizer storing time and
the climatic conditions.
• the working conditions.
I
The fertilizer flowing behaviour can
change even after a short storing time.
Therefore again determine the fertilizer
calibration factor of the fertilizer to be
spread.
I
Always again determine the fertilizer
calibration factor
• if the spread rate changes.
• if deviations between the theoretica
l
and the actual spread rate occur.
Determine stationary the fertilizer calibration factor
I
During the fertilizer calibration determina-
tion the spread rate entered
into
AMADOS
+
may not exceed the value re-
sulting from the columns " max.
spread
rate to be
entered during the fertilizer
calibration factor determination for 6, 8,
10 km/h".
Tabelle 2: "Maximum spread rate to be entered
during the fertilizer calibration factor de-
termination in dependence of working
width and operational speed"
max. spread rate to be entered
[kg/ha] when determining the fertil-
izer calibration factor for the opera-
tional speed
Working width
[m]
6 k.p.h.
km/h
8 k.p.h.
km/h
10 k.p.h.
km/h
10 3000 2400 1800
12 2500 2000 1500
15 2000 1600 1200
16 1900 1520 1140
18 1688 1350 1013
20 1525 1220 915
21 1450 1160 870
24 1263 1010 758
27 1125 900 675
28 1088 870 653
30 1013 810 608
32 950 760 570
36 850 680 510